Interior door installation in Upstate SC and western NCSend photos for a free quote

How much does interior door installation cost in Greenville, SC? (2026)

By the DoorFlux Pro installation team. Updated 2026-11-03.

In the Greenville area in 2026, labor to install a standard interior door typically runs $150 to $350 per door when the opening is square. European systems run $220 to $500 and hidden flush doors $410 to $710. The door is priced separately. Older homes cost more because frames often need shimming or the door needs hand fitting.

Labor ranges by door type

ServiceTypical labor rangeUnit
Interior door installation$150–$350per door
Hidden (flush) door installation$410–$710per door
European door installation$220–$500per door
Pocket door installation$400–$700per door
Barn door installation$180–$400per door
Closet door installation$100–$250per opening
Interior French doors$350–$750per pair
Door adjustment and repair$140–$210per visit
Non-standard size (taller than 80″ or wider than 36″)+$50–150per door
Replacing the old frame (jamb) completely+$80–150per door
Measurement visit with written report$100credited to your job

These are planning ranges for labor in the Greenville area in 2026, not a bid. The door itself is not included. Your quote depends on the opening, door type and hardware. 5+ doors in one visit: 10% off labor.

What raises the price

  • Removing an old frame instead of reusing it
  • Out-of-square openings, common in older homes near downtown Greenville and Spartanburg
  • Non-standard sizes that need a slab trimmed by hand
  • Cutting in hinges and locks on doors that are not pre-drilled
  • New casing or jamb extensions
  • Pocket and hidden doors, which need two visits and coordination with a drywall crew

What is not included

The door and hardware, drywall work and painting. We install doors only. For hidden and pocket doors, your drywall and paint contractor finishes the wall between our visits.

Permits and contractor registration

In South Carolina, residential specialty contractors are registered with the Residential Builders Commission at the SC Department of Labor, Licensing and Regulation. Local permit rules vary by city and county; we check them before work starts.

Questions

Is it cheaper to replace only the slab?

Usually yes, if the existing frame is solid and square. If the frame is damaged or out of square, a prehung door often costs less in total because it avoids hours of fitting.

Do I need a permit?

Replacing an interior door in the same opening usually does not need a permit, but rules vary by city and county. Structural changes, such as a pocket door in a load-bearing wall, do.

How can I lower the cost?

Group several doors into one visit (5+ doors get 10% off labor), buy pre-drilled doors, and send clear photos so we can quote without extra visits.

Get a free estimate